Use access key #2 to skip to page content.

Clever German Engineers

Recs

7

January 31, 2012 – Comments (2)

This is a cool story

---------------------------------

Whale acrobatics inspire a faster helicopter
20:28 31 January 2012
Aerospace
Paul Marks, senior technology correspondent

http://www.newscientist.com/blogs/onepercent/2012/01/whale-acrobatics-inspire-a-go-.html

The way the humpback whale, Megaptera novaeangliae, manages to perform underwater acrobatics and turn on a dime - despite having pendulous, outsize pectoral fins - has inspired aviation engineers in Göttingen, Germany to make a faster, quieter helicopter rotor blade.

A helicopter has a rotor whose aerofoil-shaped blades provides lift, directional control and forward thrust. As the rotor spins, the advancing blade - which is moving in the same direction as the craft - is travelling faster than the retreating blade on the opposite side. These different speeds make for turbulence, vibration and instability - especially during fast flight and whilst turning, when the retreating blade is more likely to lose lift and "stall". As a result, helicopter engineers spend a lot of time trying to minimise this effect.

Noting the humpback's agility in water, Kai Richter and colleagues at the German Aerospace Centre (DLR) wondered if something analagous to the bumps on its pectoral fins - known to provide lift underwater and boost the creature's buoyancy - could help them improve chopper design. Scaling those bumps down relative to a rotor's width, they made 6-millimetre-diameter rubber grommets and fastened 186 of them  to the leading edges of the rotors on a test helicopter (see picture, above).

It did indeed significantly delay stalling and the difference has already been noticed by test pilots, Kai says, providing a smoother ride. They have been encouraged enough by their results to file patents on the idea, and they now plan further tests. If their whale mimicry pans out, it won't involve clunky rubber grommets: the bumps would be milled into blades during manufacturing.

2 Comments – Post Your Own

#1) On February 01, 2012 at 12:45 PM, lemoneater (80.38) wrote:

Very neat! I sent the article to my husband and father-in-law who have enough engineering knowledge to really appreciate it.

Couldn't this also be used on Subs which are in the water just like whales?

Report this comment
#2) On February 03, 2012 at 12:23 PM, binve (< 20) wrote:

lemoneater ,

Thanks!

>>Couldn't this also be used on Subs which are in the water just like whales?<<

Now that's an idea!..

Report this comment

Featured Broker Partners


Advertisement